Crack wep wlan_xx

Create a network interface which runs in monitor mode. To do this enter command airmon-ng start wlan0. Make sure to replace wlan0 in command with the interface name that your card have. Here, mon0 has been created. Now, you might or might not get the warning appearing in the below screenshot which tells other processes using the network which can create the problem.

So, you can kill them using the syntax: kill PID if you know those processes are not important for you at the moment. It can take time to all the available WiFi networks in range. First enter the command airplay-ng -1 0 -a FB:A9:B1 mon0 to perform fake authentication -1 in command to the network. Hit enter and the command will start doing attack to WEP WiFi Access point and you can see the Data value increasing at enormously fast rate. In below screenshot the bell Once you have enough data in the file bell It will test all the data values available in key file and automatically show you the key it found by testing data in file.

It will be in hex format but work just fine. Now, to use this key, firstly start the processes you have killed in Step 1 above using the command I have used below. Finally enter the cracked key without colon as the password of targeted WEP WiFi Network and it will be connected. Tags: Hack WiFi X. Saurabh Saha March 14, By using this tool, you can determine the key stream and the WEP key for the target network using statistical attacks.

The WPA key or security key is the password that is used to connect to your wireless network. Your modem or router will have a password called this. When prompted, you will need to enter the WEP Key you have already created. Table of contents 1. Using aircrack-ng is even more easy. We just type in aircrack-ng and after that we are going to write the file name.

The file name is similar to the file name in airodump-ng. It will actually be the file in which we are capturing the packets. So it is going to get more clear when we actually do it. So now I am going to say airodump-ng wlan0mon to check the Wi-Fi available for us and here is our test network.

After that we specify the channel, and the channel is 1, and then we give it the output file name. So we can say here output-wep-crack or you can give it any name you want and after that we are going to say wlan0mon. So, it is very easy. Airodump-ng —bssid of the Wi-Fi or network we are trying to hack or crack the key, then channel and then the name of output file and then the interface monitor mode it is running on.

So it is very easy. We say aircrack-ng and after that we have to put the file name. So we say output -wep-crack and then the capture file.

So, we have this file available. We can say aircrack-ng then after that we can copy it or we can just type in output and then capture file. So it is saying that it failed to find two packets with the similar IV or similar random number so it is going to try next on 5, IVs. And you remember in the last videos we said that data is the number of useful packets we captured.

So now it can get more clear to you that these are the packets with different kind of IVs. For example, we have captured 2, packets right now and each of those packets have a different IV. So we actually need an IV or we need two packets with different IVs. So it is going to keep capturing those data packets and then keep comparing them. Aircrack-ng will be comparing them and airodump-ng is actually capturing the packets.

And it can take some time.